Cane Crono Guide de l'utilisateur télécharger pdf (Page 76)

MAN 01/EN/03 CRONO PAR 50 06/13

Auto

DISPLAYING THE SETTINGS

This function displays the programmed pump settings.

To display the pump settings, the pump must be set to OFF

or StoP.

If the settings are displayed when the settings lock is set to

L0 (settings lock off) the settings ash, and can be modied.

If the setting are displayed when the settings lock is set to

L1 (settings lock on, with the display showing the "lock"

indicator), the parameters do not ash and are not modiable

(with the exception of the time - see page 61).

SECTION 14

• When the settings lock is on (L1), you can, if needed, change the time set-

tings using the following procedure:

1. press the

button for about 1 second: the display shows the ashing hour

and minute settings;

2. press the

button. The hour value begins to ash and you can change

the hour and minute settings. This function can be used, for example, if you

transfer to a different time zone.

• To display the ows assigned over the daily 24-hour period, press the

button.

NOTES

Proceed as follows:

1. press the

button for about 4 seconds: the display shows the time;

2. do not press any button for about 20 seconds, and the display will go back

to OFF or StoP;

3. press the

button again to show the other settings in sequence: hours,

minutes, bolus dose volume, interval between bolus doses, ow rates,

ows over the daily 24-hour period and partial volume.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 113 114

Pas de commentaire

Cane Crono Guide de l'utilisateur Page 76